Blog Post #4
This week for my Genius Hour Project all I needed to do was hang the door. I started by measuring how high I needed the door to hang and then measuring up from the highest point of the floor (I own a old house so the floor is not perfectly flat). I then measured and marked the height of the track system the door would hang on. Next I measured how high i needed the wheels and brackets to sit on the door and drilled pilot holes in the door to attach the brackets and wheels. Next I went to hang the track, however the first stud i found turned out to be spaced oddly so none of my remaining screws hit studs meaning I needed to remove them and start over again. I found another stud and re-hung the track properly by making sure the studs were properly spaced out and using a level to ensure it was straight so the door would not roll on its own. I then filled the initial holes and painting over them. After properly securing the track all that was left was to mount the door on the track, install door handles to either side of the door, and take pictures to show off my handy work.
Thanks for reading my blogs, I have learned lots about home renovations, and how to do them on a budget. I hope you enjoyed coming along on my Genius Hour adventure with me.
Thanks for reading my blogs, I have learned lots about home renovations, and how to do them on a budget. I hope you enjoyed coming along on my Genius Hour adventure with me.
Comments
Post a Comment